Standard

NS-EN ISO 14554-1:2000

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NS-EN ISO 14554-1:2013

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

This standard has been prepared such that: - it is independent of the type of welded construction to be manufactured; - it defines quality requirements for welding both in production plants and on site; - it provides guidance for describing a manufacturers capability to produce welded constructions to meet specified requirements; - it can also be used as a basis for assessing the manufacturer in respect to his welding capability. This standard is appropriate when demonstration of a manufacturer's or a sub-contractor's capability to produce welded constructions, fulfilling specified quality requirements, are specified in one or more of the following: - a contract between involved parties; - an application standard; - a regulatory requirement. The requirements contained within this standard can be adopted in full or can be selectively deleted by the manufacturer if not applicable to the construction concerned. They provide a flexible framework for the control of welding in the following cases: - Case 1 To provide specific requirements for resistance welding in contracts which require the manufacturer or sub-contractor to have a quality system in accordance with EN ISO 9001 or EN ISO 9002. - Case 2 To provide specific requirements for resistance welding in contracts which require the manufacturer or sub-contractor to have a quality system other than EN ISO 9001 or EN ISO 9002. - Case 3 To provide specific requirements for resistance welding as guidance to a manufacturer or sub-contractor developing a quality system. - Case 4 To provide specific requirements for references in application standards which uses resistance welding as part of its requirements or in a contract between relevant parties. It is however more appropriate for EN ISO 14554-2 to be used in such cases. For general guidelines for selection and use see EN 729-1 with the exception of Annex B and under consideration that for resistance welding only comprehensive and elementary quality requirements are specified. Annex A in this standard applies for resistance welding.

Dokumentinformasjon

  • Standard fra SN
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 25.160.01
  • ICS 25.160.10
  • National Committee SN/K 58

Produktrelasjon

Produkt livssyklus