Handlevagon 0
Dette er et testområde: Du er nå på våre testsider. Gå til standard.no for våre ordinære nettsider. standard.no
Standard

NEK IEC 62040-2:1999

Tilbaketrukket

Merknad: Denne standarden har en ny utgave: NEK IEC 62040-2:2016

Forhåndsvisning Forhåndsvisning er ikke tilgjengelig

Rettelser og tillegg kjøpes separat.

Språk
Tjenester

Omfang

Applies to single UPS units or UPS systems comprising a number of interconnected UPS and associated control/switchgear forming a single power system, intended to be installed in any operator accessible area or in separated electrical locations, connected to either industrial or public low voltage supply networks. Takes precedence over all aspects of the generic standards, and no additional testing is necessary. Takes into account differing test conditions necessary to encompass the range of physical sizes and power ratings of UPS. A UPS unit or system shall meet the relevant requirements of this standard as a stand-alone product. Special installation environments are not covered, nor are fault conditions of UPS taken into account. This standard does not cover d.c. supplied electronic ballast (IEC 60924 and IEC 60925) or UPS based on rotating machines. States EMC requirements, test methods, minimum performance levels.

Dokumentinformasjon

  • Standard fra NEK
  • Publisert:
  • Tilbaketrukket:
  • Utgave: 1.0
  • Versjon: 1
  • Varetype: NAT
  • Products.Specs.pages
  • ICS 17.220
  • ICS 29.200
  • ICS 33.100.10
  • National Committee NEK/NK22

Produktrelasjon